SSL 2+ USB Audio Interface vs Focusrite Scarlett 2i2 (4th Gen) compared — specs, features, and which one to buy for your setup. See the full breakdown on CreatorConfig.
The Ruling
Neither one leads on more of the chart than the other: the SSL 2+ USB Audio Interface takes Monitoring and Connectivity, the Focusrite Scarlett 2i2 (4th Gen) takes Preamps and Creator Features. With the trade even, $0.99 is the tiebreaker, and the SSL 2+ USB Audio Interface is the cheaper side of it.
Unless…
At a Glance
Every axis is scored out of 10 from the catalog specs below. The scores are relative to the products on this page, so a 10 means “best of these”, not “perfect”, and two identical columns mean the catalog genuinely cannot separate them. Axes the catalog holds no figure for on both sides are left off entirely rather than guessed at.
| Category | SSL 2+ USB Audio Interface | Focusrite Scarlett 2i2 (4th Gen) |
|---|---|---|
| Audio Resolution | 10/10 | 10/10 |
| Preamps | 9.1/10 | 10/10 |
| Mic Inputs | 10/10 | 10/10 |
| Monitoring | 10/10 | 7.5/10 |
| Creator Features | 5/10 | 10/10 |
| Connectivity | 10/10 | 5/10 |
The Split
Desktop audio interface intended for creator workflows, microphone input, monitoring, and clean signal routing.
On paper the SSL 2+ USB Audio Interface takes headphone outputs (2, +1) and TRS outputs (4, +2). It gives up loopback and preamp gain to the Focusrite Scarlett 2i2 (4th Gen). The two are priced the same, so price does not decide it.
Leads on
A second headphone output lets a guest monitor without a splitter.
More TRS outputs allow routing to studio monitors and outboard gear.
Two-channel USB-C audio interface with studio-grade preamps for recording, streaming, and vocals.
On paper the Focusrite Scarlett 2i2 (4th Gen) takes loopback (Yes), preamp gain (69dB, +7dB) and dynamic range (120dB, +9.5dB). It gives up headphone outputs and TRS outputs to the SSL 2+ USB Audio Interface. The two are priced the same, so price does not decide it.
Leads on
Loopback routes computer audio back into the stream without a second interface or cable.
More gain drives quiet dynamic microphones like the SM7B without a separate booster.
Wider converter dynamic range means less noise between the quietest and loudest parts of a take.
These 8 specs are the same on both of them, so none of it is part of the decision.
The Record
A group is won by whoever takes more of its rows outright. Specs the catalog cannot rank are shown but never decide a group.
Bottom Line
The SSL 2+ USB Audio Interface is the pick on the specs the catalog holds, but “better on paper” and “right for you” are different questions. Each case below names what the product is actually good at and who that suits.
The clearest difference is loopback, which the Focusrite Scarlett 2i2 (4th Gen) has and the SSL 2+ USB Audio Interface does not. Across the catalog's specification sheet the two differ on 5 specs. They match on 8 specs, including connection type, sample rate and bit depth. Two audio interfaces from SSL and Focusrite, each taking a different approach to audio quality and I/O flexibility.
It is a toss-up — take the SSL 2+ USB Audio Interface. Neither one leads on more of the chart than the other: the SSL 2+ USB Audio Interface takes Monitoring and Connectivity, the Focusrite Scarlett 2i2 (4th Gen) takes Preamps and Creator Features. With the trade even, $0.99 is the tiebreaker, and the SSL 2+ USB Audio Interface is the cheaper side of it.
Both share 8 specifications in the catalog, including connection type (usb-c, xlr, trs), sample rate (192kHz), bit depth (24-bit) and phantom power (Yes), among others. None of those is a reason to pick one over the other.