M-Audio M-Track 2x2M-C vs BEACN Studio Audio Interface compared — specs, features, and which one to buy for your setup. See the full breakdown on CreatorConfig.
The Ruling
The BEACN Studio Audio Interface wins Preamps and Creator Features — but only just, and the rest of the chart is close. It is the pricier of the two at $249, so the M-Audio M-Track 2x2M-C stays the pick if $50 matters more than those specs.
Unless…
At a Glance
Every axis is scored out of 10 from the catalog specs below. The scores are relative to the products on this page, so a 10 means “best of these”, not “perfect”, and two identical columns mean the catalog genuinely cannot separate them. Axes the catalog holds no figure for on both sides are left off entirely rather than guessed at.
| Category | M-Audio M-Track 2x2M-C | BEACN Studio Audio Interface |
|---|---|---|
| Audio Resolution | 10/10 | 6.3/10 |
| Preamps | 8/10 | 10/10 |
| Mic Inputs | 10/10 | 10/10 |
| Monitoring | 10/10 | 10/10 |
| Creator Features | 5/10 | 10/10 |
| Power | 10/10 | 10/10 |
The Split
Desktop audio interface intended for creator workflows, microphone input, monitoring, and clean signal routing.
On paper the M-Audio M-Track 2x2M-C takes sample rate (192kHz, +144kHz). It gives up loopback and preamp gain to the BEACN Studio Audio Interface. It is the cheaper of the two, by $50.00.
Leads on
Higher sample rates capture more audio detail — important for professional recording and mixing.
Streaming-focused audio interface with creator routing, clean preamps, and low-latency monitoring.
On paper the BEACN Studio Audio Interface takes loopback (Yes) and preamp gain (69dB, +14dB). It gives up sample rate to the M-Audio M-Track 2x2M-C. That costs $50.00 more than the M-Audio M-Track 2x2M-C.
Leads on
Loopback routes computer audio back into the stream without a second interface or cable.
More gain drives quiet dynamic microphones like the SM7B without a separate booster.
These 9 specs are the same on both of them, so none of it is part of the decision.
The Record
A group is won by whoever takes more of its rows outright. Specs the catalog cannot rank are shown but never decide a group.
Bottom Line
The BEACN Studio Audio Interface is the pick on the specs the catalog holds, but “better on paper” and “right for you” are different questions. Each case below names what the product is actually good at and who that suits.
The clearest difference is loopback, which the BEACN Studio Audio Interface has and the M-Audio M-Track 2x2M-C does not. Across the catalog's specification sheet the two differ on 3 specs. They match on 9 specs, including connection type, operating system and bit depth. Two audio interfaces from M-Audio and BEACN, each taking a different approach to audio quality and I/O flexibility.
Get the BEACN Studio Audio Interface, narrowly. The BEACN Studio Audio Interface wins Preamps and Creator Features — but only just, and the rest of the chart is close. It is the pricier of the two at $249, so the M-Audio M-Track 2x2M-C stays the pick if $50 matters more than those specs.
Both share 9 specifications in the catalog, including connection type (usb-c, xlr, trs), operating system (windows, macos), bit depth (24-bit) and phantom power (Yes), among others. None of those is a reason to pick one over the other.
The BEACN Studio Audio Interface costs $249.00 against $199.00, a difference of $50. The premium buys loopback (Yes) and preamp gain (69dB). Whether that is worth it depends on which of those you would actually use.