Focusrite Scarlett 2i2 (3rd Gen) vs Universal Audio Volt 276 USB-C Interface compared — specs, features, and which one to buy for your setup. See the full breakdown on CreatorConfig.
The Ruling
Neither one leads on more of the chart than the other: the Focusrite Scarlett 2i2 (3rd Gen) takes Preamps, the Universal Audio Volt 276 USB-C Interface takes Connectivity. With the trade even, $39.01 is the tiebreaker, and the Focusrite Scarlett 2i2 (3rd Gen) is the cheaper side of it.
Unless…
At a Glance
Every axis is scored out of 10 from the catalog specs below. The scores are relative to the products on this page, so a 10 means “best of these”, not “perfect”, and two identical columns mean the catalog genuinely cannot separate them. Axes the catalog holds no figure for on both sides are left off entirely rather than guessed at.
| Category | Focusrite Scarlett 2i2 (3rd Gen) | Universal Audio Volt 276 USB-C Interface |
|---|---|---|
| Audio Resolution | 10/10 | 10/10 |
| Preamps | 10/10 | 7/10 |
| Mic Inputs | 10/10 | 10/10 |
| Monitoring | 10/10 | 10/10 |
| Creator Features | 10/10 | 10/10 |
| Connectivity | 5/10 | 10/10 |
The Split
Popular 2-in/2-out USB audio interface with low-noise preamps and direct monitoring.
On paper the Focusrite Scarlett 2i2 (3rd Gen) takes preamp gain (56dB, +1dB). It gives up TRS outputs to the Universal Audio Volt 276 USB-C Interface. It is the cheaper of the two, by $39.01.
Leads on
More gain drives quiet dynamic microphones like the SM7B without a separate booster.
Desktop audio interface intended for creator workflows, microphone input, monitoring, and clean signal routing.
On paper the Universal Audio Volt 276 USB-C Interface takes TRS outputs (4, +2). It gives up preamp gain to the Focusrite Scarlett 2i2 (3rd Gen). That costs $39.01 more than the Focusrite Scarlett 2i2 (3rd Gen).
Leads on
More TRS outputs allow routing to studio monitors and outboard gear.
These 11 specs are the same on both of them, so none of it is part of the decision.
The Record
A group is won by whoever takes more of its rows outright. Specs the catalog cannot rank are shown but never decide a group.
Bottom Line
The Focusrite Scarlett 2i2 (3rd Gen) is the pick on the specs the catalog holds, but “better on paper” and “right for you” are different questions. Each case below names what the product is actually good at and who that suits.
The largest gap is TRS outputs, where the Universal Audio Volt 276 USB-C Interface leads — 4 against 2. Across the catalog's specification sheet the two differ on 2 specs. They match on 11 specs, including connection type, sample rate and bit depth. Two audio interfaces from Focusrite and Universal Audio, each taking a different approach to audio quality and I/O flexibility.
It is a toss-up — take the Focusrite Scarlett 2i2 (3rd Gen). Neither one leads on more of the chart than the other: the Focusrite Scarlett 2i2 (3rd Gen) takes Preamps, the Universal Audio Volt 276 USB-C Interface takes Connectivity. With the trade even, $39.01 is the tiebreaker, and the Focusrite Scarlett 2i2 (3rd Gen) is the cheaper side of it.
Both share 11 specifications in the catalog, including connection type (usb-c, xlr, trs), sample rate (192kHz), bit depth (24-bit) and max sample rate (192kHz), among others. None of those is a reason to pick one over the other.
The Universal Audio Volt 276 USB-C Interface costs $189.00 against $149.99, a difference of $39. The premium buys TRS outputs (4). Whether that is worth it depends on which of those you would actually use.