Arturia MiniFuse 2 vs BEACN Studio Audio Interface compared — specs, features, and which one to buy for your setup. See the full breakdown on CreatorConfig.
The Ruling
Neither one leads on more of the chart than the other: the Arturia MiniFuse 2 takes Audio Resolution, the BEACN Studio Audio Interface takes Preamps. With the trade even, $99.01 is the tiebreaker, and the Arturia MiniFuse 2 is the cheaper side of it.
Unless…
At a Glance
Every axis is scored out of 10 from the catalog specs below. The scores are relative to the products on this page, so a 10 means “best of these”, not “perfect”, and two identical columns mean the catalog genuinely cannot separate them. Axes the catalog holds no figure for on both sides are left off entirely rather than guessed at.
| Category | Arturia MiniFuse 2 | BEACN Studio Audio Interface |
|---|---|---|
| Audio Resolution | 10/10 | 6.3/10 |
| Preamps | 8.1/10 | 10/10 |
| Mic Inputs | 10/10 | 10/10 |
| Monitoring | 10/10 | 10/10 |
| Creator Features | 10/10 | 10/10 |
| Power | 10/10 | 10/10 |
The Split
USB-C audio interface with dual combo inputs, direct monitoring, and creator-ready loopback support.
On paper the Arturia MiniFuse 2 takes sample rate (192kHz, +144kHz). It gives up preamp gain to the BEACN Studio Audio Interface. It is the cheaper of the two, by $99.01.
Leads on
Higher sample rates capture more audio detail — important for professional recording and mixing.
Streaming-focused audio interface with creator routing, clean preamps, and low-latency monitoring.
On paper the BEACN Studio Audio Interface takes preamp gain (69dB, +13dB). It gives up sample rate to the Arturia MiniFuse 2. That costs $99.01 more than the Arturia MiniFuse 2.
Leads on
More gain drives quiet dynamic microphones like the SM7B without a separate booster.
These 9 specs are the same on both of them, so none of it is part of the decision.
The Record
A group is won by whoever takes more of its rows outright. Specs the catalog cannot rank are shown but never decide a group.
Bottom Line
The Arturia MiniFuse 2 is the pick on the specs the catalog holds, but “better on paper” and “right for you” are different questions. Each case below names what the product is actually good at and who that suits.
The largest gap is sample rate, where the Arturia MiniFuse 2 leads — 192kHz against 48kHz. Across the catalog's specification sheet the two differ on 2 specs. They match on 9 specs, including connection type, bit depth and phantom power. Two audio interfaces from Arturia and BEACN, each taking a different approach to audio quality and I/O flexibility.
It is a toss-up — take the Arturia MiniFuse 2. Neither one leads on more of the chart than the other: the Arturia MiniFuse 2 takes Audio Resolution, the BEACN Studio Audio Interface takes Preamps. With the trade even, $99.01 is the tiebreaker, and the Arturia MiniFuse 2 is the cheaper side of it.
Both share 9 specifications in the catalog, including connection type (usb-c, xlr, trs), bit depth (24-bit), phantom power (Yes) and XLR inputs (2), among others. None of those is a reason to pick one over the other.
The BEACN Studio Audio Interface costs $249.00 against $149.99, a difference of $99. The premium buys preamp gain (69dB). Whether that is worth it depends on which of those you would actually use.